Number P0106: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance
The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P01
Can you drive with P0106?
Severity: Fix promptly — drivability fault. Short trips at moderate speed only. If the car has entered limp mode (won't rev, stuck in one gear), have it towed rather than forcing it.
If you ignore it: Limp-mode faults tend to strand you, and several of them (misfires, throttle faults) damage other parts while you wait.
This is the #62 most common code in our top-150 library, in the fuel trim & air metering family (Powertrain system). Severity is Number Nest's editorial triage — if the light is flashing or the car feels unsafe, stop driving it whatever any page says.
What P0106 means
The manifold absolute pressure (MAP) sensor measures the pressure behind the throttle; on vehicles without a separate barometric sensor it also supplies the ambient pressure, read at key-on or wide-open throttle – hence 'MAP/BARO'. It is a three-wire sensor with 5 V reference, ground and signal. P0106 is a plausibility fault: the signal is electrically valid but implausible – stuck, offset or drifting. Two tests are common. With the engine stopped, all pressures equalise, so MAP must match ambient (and boost) pressure; Ford allows 1.5–3 inHg. While running, MAP is compared with a value modelled from air mass, throttle and speed – GM blames the MAP sensor above about 23–30 kPa error, with two trips on petrol and one on diesel. Turbo engines with three sensors find the odd one out by majority. Besides the sensor, intake or boost leaks often cause it.
Systems involved: manifold absolute pressure sensor, intake manifold, sensor wiring, boost pressure sensor.
Causes, ranked by likelihood
| # | Cause | Likelihood |
|---|---|---|
| 1 | Vacuum leak at the intake manifold or boost leak (hose, clamp, charge air cooler) | most likely |
| 2 | Sensor oiled or sooted, port blocked (EGR soot), characteristic drifted | most likely |
| 3 | High resistance in signal, reference or ground wire | possible |
| 4 | Comparison sensor wrong, or mechanical cause (dirty throttle, EGR stuck open) | possible |
Check them in order — the list is ranked so the likely, cheaper causes come before the expensive part.
Symptoms you may notice
- Check engine light on
- Rough idle, hesitation, poor response
- Higher consumption, black smoke possible on diesels
- Loss of power or limp mode on turbo engines
Misdiagnosis traps
- Replacing the part named by the code title without testing. The code reports a failed self-test; the cause list above is ranked so the likely, cheap causes are checked before the expensive part is condemned.
- Clearing the code and declaring victory when the light stays off for a day — the monitor that sets this code runs only under specific driving conditions.
(General diagnostic guidance for this code family — no code-specific trap is published for this code.)
How a good shop confirms it
- Confirm the code and record any companion codes — companions narrow the system fast.
- Inspect the affected components and their wiring/connectors for damage, corrosion and looseness.
- Test the top-ranked cause with live data or a multimeter before replacing anything.
(Standard diagnostic path for this family, labeled as general guidance.)
Repair options & costs
| Repair | Shop total (parts + labor) | DIY (parts only) | Difficulty |
|---|---|---|---|
| Mass air flow (MAF) sensor | $158 – $420 | $120 – $320 (parts only) | 1/5 |
| Intake / vacuum leak repair (gaskets, hoses) | $338 – $838 | $150 – $400 (parts only) | 3/5 |
National ranges from Number Nest's cost model (midsize car, independent shop, US-average labor). Published cross-check — Mass air flow (MAF) sensor: CarMD 2026 national average $346.
OBDex repair data for this code rates the job difficulty medium with a typical labor time in the 0.5–2 hour range and DIY possible: yes.
Price this repair in your state
Estimated total: — (midsize car, independent shop)
Frequently asked questions
How much does it cost to fix P0106?
The fix most associated with this code — mass air flow (maf) sensor — runs $158 – $420 at an independent shop for a midsize car in our cost model (parts + labor, US average). The code names a system, not a part, so confirm the cause before spending: the ranked causes above are ordered by likelihood.
Can I drive with P0106?
See the can-you-drive verdict above — it is based on the system involved and the cascading-damage risk, and it is our editorial triage, not a manufacturer instruction. If the light is flashing or the car feels unsafe, stop driving it regardless of any code.
Will P0106 clear itself?
If the fault was a one-off (a loose cap, a cold-start glitch), the light can go out after several clean trips and the code ages into history. A fault that is still present re-sets the code as soon as the car runs that self-test again — monitors run under specific conditions, which is why "it hasn't come back in two days" is not proof of a fix.
Will my car fail inspection with P0106?
In states with OBD-based emissions inspection, yes — an illuminated check-engine light or an incomplete readiness monitor fails the test regardless of what the tailpipe would show. C-codes (ABS) fall under safety inspection instead in states that have one.
What should I check first for P0106?
The first item on the ranked-causes list above — it is ranked likelihood-first for exactly this reason — plus the free checks: recent work in the area (connectors left loose are a classic), fluid levels, and the battery and grounds on electrical codes.
Where this data comes from
Code facts, causes and symptoms come from OBDex — an open dataset of independently authored descriptions of the standardized generic OBD-II codes (CC0 1.0, public domain; github.com/foerbsnavi/OBDex). The SAE J2012 document itself is copyrighted and is not reproduced here. Cost ranges are Number Nest's own US planning model: national parts and labor ranges cross-checked against the CarMD Vehicle Health Index 2026 published averages, with labor adjustable by the BLS OEWS May 2025 state wage index for auto technicians (occupation 49-3023) — a wage index, not a surveyed shop rate. Severity and can-you-drive notes are our editorial triage, not a manufacturer instruction.