Number P0459: EVAP System Purge Control Valve A Circuit High
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Purge valve A is switched to ground by the module and fed from the main relay. P0459 means its control wire is
Can you drive with P0459?
Severity: Plan the repair. Yes — this is an emissions-system fault. The car will generally drive normally, but it will fail an emissions inspection with the light on.
If you ignore it: Fuel economy and emissions creep up, and some faults in this family (rich/lean running) stress the catalyst over time.
This is the #102 most common code in our top-150 library, in the evap — fuel vapor system family (Powertrain system). Severity is Number Nest's editorial triage — if the light is flashing or the car feels unsafe, stop driving it whatever any page says.
What P0459 means
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Purge valve A is switched to ground by the module and fed from the main relay. P0459 means its control wire is shorted to positive, detected with the driver switched on, when the line should sit at ground (GM 20 of 25 samples, MIL after two trips; Saab ME9 above 4.6 V). The valve then cannot open, the canister is not purged and fills up; the driver protects itself and the leak tests are suspended.
Systems involved: EVAP purge valve, purge valve wiring, engine control module (ECM/PCM).
Causes, ranked by likelihood
| # | Cause | Likelihood |
|---|---|---|
| 1 | Control wire shorted to battery voltage or supply | most likely |
| 2 | Purge valve coil low-resistance (shorted turns) | possible |
| 3 | Connector or harness damaged | possible |
| 4 | Engine module | less common |
Check them in order — the list is ranked so the likely, cheaper causes come before the expensive part.
Symptoms you may notice
- Check engine light on
- Fuel smell when the canister is full
- EVAP readiness not set
Misdiagnosis traps
- Replacing the part named by the code title without testing. The code reports a failed self-test; the cause list above is ranked so the likely, cheap causes are checked before the expensive part is condemned.
- Clearing the code and declaring victory when the light stays off for a day — the monitor that sets this code runs only under specific driving conditions.
(General diagnostic guidance for this code family — no code-specific trap is published for this code.)
How a good shop confirms it
- Confirm the code and record any companion codes — companions narrow the system fast.
- Inspect the affected components and their wiring/connectors for damage, corrosion and looseness.
- Test the top-ranked cause with live data or a multimeter before replacing anything.
(Standard diagnostic path for this family, labeled as general guidance.)
Repair options & costs
| Repair | Shop total (parts + labor) | DIY (parts only) | Difficulty |
|---|---|---|---|
| EVAP purge valve / solenoid | $68 – $198 | $30 – $110 (parts only) | 1/5 |
| EVAP leak diagnosis (smoke test) + gas cap | $73 – $248 | $10 – $60 (parts only) | 1/5 |
National ranges from Number Nest's cost model (midsize car, independent shop, US-average labor). Published cross-check — EVAP purge valve / solenoid: CarMD 2026 national average $172.
OBDex repair data for this code rates the job difficulty easy with a typical labor time in the 0.3–1.5 hour range and DIY possible: yes.
Price this repair in your state
Estimated total: — (midsize car, independent shop)
Frequently asked questions
How much does it cost to fix P0459?
The fix most associated with this code — evap purge valve / solenoid — runs $68 – $198 at an independent shop for a midsize car in our cost model (parts + labor, US average). The code names a system, not a part, so confirm the cause before spending: the ranked causes above are ordered by likelihood.
Can I drive with P0459?
See the can-you-drive verdict above — it is based on the system involved and the cascading-damage risk, and it is our editorial triage, not a manufacturer instruction. If the light is flashing or the car feels unsafe, stop driving it regardless of any code.
Will P0459 clear itself?
If the fault was a one-off (a loose cap, a cold-start glitch), the light can go out after several clean trips and the code ages into history. A fault that is still present re-sets the code as soon as the car runs that self-test again — monitors run under specific conditions, which is why "it hasn't come back in two days" is not proof of a fix.
Will my car fail inspection with P0459?
In states with OBD-based emissions inspection, yes — an illuminated check-engine light or an incomplete readiness monitor fails the test regardless of what the tailpipe would show. C-codes (ABS) fall under safety inspection instead in states that have one.
What should I check first for P0459?
The first item on the ranked-causes list above — it is ranked likelihood-first for exactly this reason — plus the free checks: recent work in the area (connectors left loose are a classic), fluid levels, and the battery and grounds on electrical codes.
Where this data comes from
Code facts, causes and symptoms come from OBDex — an open dataset of independently authored descriptions of the standardized generic OBD-II codes (CC0 1.0, public domain; github.com/foerbsnavi/OBDex). The SAE J2012 document itself is copyrighted and is not reproduced here. Cost ranges are Number Nest's own US planning model: national parts and labor ranges cross-checked against the CarMD Vehicle Health Index 2026 published averages, with labor adjustable by the BLS OEWS May 2025 state wage index for auto technicians (occupation 49-3023) — a wage index, not a surveyed shop rate. Severity and can-you-drive notes are our editorial triage, not a manufacturer instruction.