Number P0506: Idle Control System RPM - Lower Than Expected
CARB requires the idle speed control to be monitored: petrol engines must flag a fault if the target idle speed is not reached within +200/−100 rpm, diesels within ±30 %. Older engines use a separate idle air control valve that bypasses the closed throttle; with electronic throttle the throttle itse
Can you drive with P0506?
Severity: Plan the repair. Yes — this is an emissions-system fault. The car will generally drive normally, but it will fail an emissions inspection with the light on.
If you ignore it: Fuel economy and emissions creep up, and some faults in this family (rich/lean running) stress the catalyst over time.
This is the #107 most common code in our top-150 library, in the idle & throttle control family (Powertrain system). Severity is Number Nest's editorial triage — if the light is flashing or the car feels unsafe, stop driving it whatever any page says.
What P0506 means
CARB requires the idle speed control to be monitored: petrol engines must flag a fault if the target idle speed is not reached within +200/−100 rpm, diesels within ±30 %. Older engines use a separate idle air control valve that bypasses the closed throttle; with electronic throttle the throttle itself controls idle and no separate valve exists. P0506 means the idle speed of the warm engine at standstill stays too low despite fully used control. GM uses more than 91 rpm filtered for 10 s (MIL after two trips), Ford petrol −100 rpm plus a correction above 1 lb/min, Ford diesel −100 rpm for 5 s, Subaru −100 rpm with the correction at its limit for 10 s three times. Typical are deposits, extra load or a restricted intake or exhaust.
Systems involved: idle control, throttle body, idle air control valve, engine control module (ECM/PCM).
Causes, ranked by likelihood
| # | Cause | Likelihood |
|---|---|---|
| 1 | Deposits at the throttle or bypass channel, or gummed idle valve | most likely |
| 2 | Extra load: stiff accessory drive, gearbox or converter | possible |
| 3 | Intake or exhaust restricted (air filter, catalyst) | possible |
| 4 | Idle valve or throttle actuator faulty, wrong learned value | possible |
| 5 | Mechanical engine damage (low compression) | less common |
Check them in order — the list is ranked so the likely, cheaper causes come before the expensive part.
Symptoms you may notice
- Idle too low, engine shakes
- Engine stalls when stopping or with A/C on
- Check engine light after two trips
Misdiagnosis traps
- Replacing the part named by the code title without testing. The code reports a failed self-test; the cause list above is ranked so the likely, cheap causes are checked before the expensive part is condemned.
- Clearing the code and declaring victory when the light stays off for a day — the monitor that sets this code runs only under specific driving conditions.
(General diagnostic guidance for this code family — no code-specific trap is published for this code.)
How a good shop confirms it
- Confirm the code and record any companion codes — companions narrow the system fast.
- Inspect the affected components and their wiring/connectors for damage, corrosion and looseness.
- Test the top-ranked cause with live data or a multimeter before replacing anything.
(Standard diagnostic path for this family, labeled as general guidance.)
Repair options & costs
| Repair | Shop total (parts + labor) | DIY (parts only) | Difficulty |
|---|---|---|---|
| Throttle body cleaning + relearn | $60 – $173 | $10 – $60 (parts only) | 1/5 |
National ranges from Number Nest's cost model (midsize car, independent shop, US-average labor).
OBDex repair data for this code rates the job difficulty medium with a typical labor time in the 0.5–2 hour range and DIY possible: yes.
Price this repair in your state
Estimated total: — (midsize car, independent shop)
Frequently asked questions
How much does it cost to fix P0506?
The fix most associated with this code — throttle body cleaning + relearn — runs $60 – $173 at an independent shop for a midsize car in our cost model (parts + labor, US average). The code names a system, not a part, so confirm the cause before spending: the ranked causes above are ordered by likelihood.
Can I drive with P0506?
See the can-you-drive verdict above — it is based on the system involved and the cascading-damage risk, and it is our editorial triage, not a manufacturer instruction. If the light is flashing or the car feels unsafe, stop driving it regardless of any code.
Will P0506 clear itself?
If the fault was a one-off (a loose cap, a cold-start glitch), the light can go out after several clean trips and the code ages into history. A fault that is still present re-sets the code as soon as the car runs that self-test again — monitors run under specific conditions, which is why "it hasn't come back in two days" is not proof of a fix.
Will my car fail inspection with P0506?
In states with OBD-based emissions inspection, yes — an illuminated check-engine light or an incomplete readiness monitor fails the test regardless of what the tailpipe would show. C-codes (ABS) fall under safety inspection instead in states that have one.
What should I check first for P0506?
The first item on the ranked-causes list above — it is ranked likelihood-first for exactly this reason — plus the free checks: recent work in the area (connectors left loose are a classic), fluid levels, and the battery and grounds on electrical codes.
Where this data comes from
Code facts, causes and symptoms come from OBDex — an open dataset of independently authored descriptions of the standardized generic OBD-II codes (CC0 1.0, public domain; github.com/foerbsnavi/OBDex). The SAE J2012 document itself is copyrighted and is not reproduced here. Cost ranges are Number Nest's own US planning model: national parts and labor ranges cross-checked against the CarMD Vehicle Health Index 2026 published averages, with labor adjustable by the BLS OEWS May 2025 state wage index for auto technicians (occupation 49-3023) — a wage index, not a surveyed shop rate. Severity and can-you-drive notes are our editorial triage, not a manufacturer instruction.